Tell us what’s going on or what you’re planning, and we’ll point you to the safest next step. Call 830-431-4530 or reach out through the contact page.
Service Areas
Texas Highlands Electric provides residential and light commercial electrical service in the Morris Ranch area of southern Gillespie County, about 8.5 miles southwest of Fredericksburg. The area is rural Hill Country between Fredericksburg and Kerrville, with ranches, acreage homes, and outbuildings spread along Morris Ranch Road and the surrounding farm-to-market routes. We serve the area with a focus on accurate troubleshooting, clean installs, and code-compliant upgrades that hold up to rural electrical demand.
Southwest of Fredericksburg, properties here spread across acreage with homes, barns, and outbuildings on long circuits, so a fault isn’t always where the symptom shows. We test under load, trace it to the source, and repair the actual failure behind a tripping breaker, dead outlet, or flickering circuit.
Interior and recessed lighting, dimmers, ceiling fans, exhaust fans, and outdoor lighting. Barn, driveway, and perimeter lighting is common on ranch properties, and we install it with weather-rated fixtures on properly protected circuits.
When a panel runs out of room or can’t carry a home, shop, and well together, we handle breaker replacements, panel repairs, and upgrades sized to what the property actually pulls.
We run dedicated circuits and wiring for barns, shops, additions, and remodels, planned for how ranch properties are used and built to stay easy to service.
Smart switches, dimmers, and lighting controls installed with the right wiring and compatible devices so they stay dependable.
For EV charging, we add a properly sized Level 2 circuit and confirm the panel can support it before installing, so it charges without tripping.
Outages run long out here, so we install the electrical side of standby and backup generators with safe connections and transfer protection for the circuits you need most.
When a solar system needs electrical work, we handle the wiring improvements and code-compliant connections it needs to tie in cleanly.
For shops and small commercial buildings in the area, we handle troubleshooting, repairs, lighting, and panel work around your schedule.
Spread-out ranch properties deal with surges, voltage drop on long runs, and circuits carrying a home plus barns, shops, and well equipment. The signs to watch are breakers tripping under combined load, lights dimming when the pump or a large tool starts, dead outlets, and anything warm at a panel or switch.
We confirm what the system is doing under normal use, explain what we found, and complete the work to code with proper sizing, protection, and secure connections. The site stays clean, we test the repair, and we confirm the original problem is resolved before finishing.
Yes. We work throughout the Morris Ranch area, including homes with barns, shops, and outbuildings.
Yes. We troubleshoot trips, flickering lights, dead outlets, and intermittent power, then repair the cause so it holds.
Yes. We handle breaker replacements, panel repairs, and full upgrades when a panel can’t keep up with the load.
Yes. We run dedicated circuits and wiring for barns, shops, and outbuildings.
Yes. We size the circuit to your panel and install to code for reliable charging.