If you need an electrician in the Mountain Home area, send us a note about what’s going on or what you want done and we’ll get back to you with next steps.
Service Areas
Electrician in Mountain Home, Texas
Mountain Home sits on the Divide in northwestern Kerr County at the intersection of SH 27 and SH 41, about 19 miles northwest of Kerrville. The community is small and rural, with properties spread out across large acreage and longer distances between the panel and where the power actually has to go. Texas Highlands Electric handles residential and light commercial electrical work throughout the Mountain Home area, working on full-time homes, ranch properties, and the outbuildings and shops that come with them.
What We Do in Mountain Home
Finding & Fixing Electrical Issues
If you’re dealing with breaker trips, flickering lights, dead outlets, or intermittent power, we diagnose first. On Mountain Home properties that often means tracing circuits across long runs and multiple buildings before pricing a repair. We find the actual cause rather than just replacing parts.
Panels, Breakers & Service Equipment
We provide breaker replacements, panel repairs, and panel upgrades when capacity or safety needs improvement. On larger Mountain Home properties, that often involves checking subpanels in outbuildings as well as the main panel. If a panel upgrade is recommended, it’s based on actual demand and condition.
Wiring for Remodels, Shops & Outbuildings
For renovations, additions, shops, and outbuildings, we handle remodel wiring, circuit additions, and the feeders and subpanels that come with running power to detached structures. Wire sizing for distance is part of the planning — short runs and long runs aren’t the same job.
Interior, Outdoor & Driveway Lighting
We install and upgrade interior fixtures, recessed lighting, dimmers, ceiling fans, and exhaust fans. Outdoor work is common out here too — driveway and gate lighting, entrance fixtures, security lighting, and barn or shop lighting on weather-rated circuits.
Level 2 EV Charger Installs
EV chargers on large rural properties usually involve a longer run from the panel and a closer look at panel capacity. We confirm what the system can handle and install with correct wire sizing and breaker protection for the distance.
Smart Switches & Lighting Controls
Smart switches, dimmers, and lighting controls installed with the right wiring and device compatibility so they work consistently.
Solar Electrical Support
We provide solar-related electrical support when needed, including system-ready upgrades and safe connections.
Backup Generator Setup
Mountain Home is far enough from major service lines that outages can run longer than they would closer to town. We install generator electrical components and transfer equipment sized to keep the loads you care about running — wells, refrigeration, HVAC, critical circuits.
Commercial Electrical Services
We support small commercial properties in the area with troubleshooting, repairs, lighting upgrades, and panel work, scheduled around your operations.
What We Get Called About in Mountain Home
A lot of calls come down to predictable issues tied to load, distance, or aging equipment:
- Outlying buildings where circuits work fine until equipment starts up
- Well pumps tripping breakers or dimming the house at startup
- Older panels carrying more load than they were originally sized for
- Outdoor outlets, gate openers, and entrance lighting that fail after weather
- Flickering lights and warm outlets caused by loose or aging connections
We diagnose what’s actually happening before recommending a fix.
How We Approach the Work
We diagnose before we quote. You’ll know what’s wrong, what we’d do about it, and roughly what it costs before any work starts. Everything is wired to code, tested under load, and clean when we leave. For properties this far out, we schedule efficiently so we’re not making short trips.
Questions From Mountain Home Customers
Do you serve properties this far out from Kerrville?
Yes. We regularly work across northwestern Kerr County and the Divide, including properties well off the main highways.
My outbuilding has power but circuits cut out when equipment runs. Why?
Often it’s the feeder. Long runs need larger wire than people assume, and a marginal conductor will work until something tries to start. We measure voltage at the building under load and tell you what it’ll take to fix it.
Why does my well pump trip the breaker or dim the lights?
Pumps draw a heavy surge at startup, which exposes voltage drop, undersized circuits, or weak connections. We test the circuit under load and correct the cause.
Can you run power to a new shop, barn, or outbuilding?
Yes. That usually means a subpanel, a properly sized feeder, and a trench. We handle the full job.
How big a generator do I need?
Depends on what you need to keep running. We size based on actual loads — wells, refrigeration, HVAC, critical circuits — and give you the honest options.
Do I need a panel upgrade to add an EV charger or generator?
Not always. We check panel condition and available capacity first. If the system can safely handle the added load, we leave it alone.
